New York State Electric & Gas customers, New York · Rebate
NYSEG NYS Clean Heat Heat Pump Incentives
Run by NYSEG (New York State Electric & Gas) through NYS Clean Heat
NYSEG electric customers in one- to four-unit homes can get up to $13,000 toward a whole-home air-source heat pump, or up to $21,000 for a geothermal system, installed by a NYS Clean Heat contractor; higher amounts for weatherized homes and Disadvantaged Communities.
Amounts
How much you get
Fixed incentive per home (per apartment for two- to four-unit buildings, up to four) set by NYSEG's NYS Clean Heat table. The amount depends on which of these fits your install.
| What you install | You get |
|---|---|
| Full load (keeping existing heating as backup), single-family homeAir-source heat pump | $4,000 |
| Full load (keeping existing heating as backup), single-family home, Weatherized TierAir-source heat pump | $8,000 |
| Full load (keeping existing heating as backup), apartment or home under 1,000 sq ftAir-source heat pump | $2,000 |
| Full load (keeping existing heating as backup), apartment or home under 1,000 sq ft, Weatherized TierAir-source heat pump | $4,000 |
| Full load, removing old fossil-fuel heating, single-family homeAir-source heat pump | $7,000 |
| Full load, removing old fossil-fuel heating, single-family home, Weatherized TierAir-source heat pump | $12,000 |
| Full load, removing old fossil-fuel heating, apartment or home under 1,000 sq ftAir-source heat pump | $3,500 |
| Full load, removing old fossil-fuel heating, apartment or home under 1,000 sq ft, Weatherized TierAir-source heat pump | $6,000 |
| Existing home, single-family homeGround-source (geothermal) heat pump | $15,000 |
| Existing home, single-family home, Weatherized TierGround-source (geothermal) heat pump | $20,000 |
| Existing home, apartment or home under 1,000 sq ftGround-source (geothermal) heat pump | $7,500 |
| Existing home, apartment or home under 1,000 sq ft, Weatherized TierGround-source (geothermal) heat pump | $10,000 |
| New construction, single-family home, Weatherized TierGround-source (geothermal) heat pump | $10,000 |
| New construction, apartment or home under 1,000 sq ft, Weatherized TierGround-source (geothermal) heat pump | $5,000 |
| Full load (keeping existing heating as backup), single-family home, Disadvantaged CommunityAir-source heat pump | $5,000 |
| Full load (keeping existing heating as backup), single-family home, Disadvantaged Community, Weatherized TierAir-source heat pump | $9,000 |
| Full load (keeping existing heating as backup), apartment or home under 1,000 sq ft, Disadvantaged CommunityAir-source heat pump | $2,500 |
| Full load (keeping existing heating as backup), apartment or home under 1,000 sq ft, Disadvantaged Community, Weatherized TierAir-source heat pump | $4,500 |
| Full load, removing old fossil-fuel heating, single-family home, Disadvantaged CommunityAir-source heat pump | $8,000 |
| Full load, removing old fossil-fuel heating, single-family home, Disadvantaged Community, Weatherized TierAir-source heat pump | $13,000 |
| Full load, removing old fossil-fuel heating, apartment or home under 1,000 sq ft, Disadvantaged CommunityAir-source heat pump | $4,000 |
| Full load, removing old fossil-fuel heating, apartment or home under 1,000 sq ft, Disadvantaged Community, Weatherized TierAir-source heat pump | $6,500 |
| Existing home, single-family home, Disadvantaged CommunityGround-source (geothermal) heat pump | $16,000 |
| Existing home, single-family home, Disadvantaged Community, Weatherized TierGround-source (geothermal) heat pump | $21,000 |
| Existing home, apartment or home under 1,000 sq ft, Disadvantaged CommunityGround-source (geothermal) heat pump | $8,000 |
| Existing home, apartment or home under 1,000 sq ft, Disadvantaged Community, Weatherized TierGround-source (geothermal) heat pump | $10,500 |
| New construction, single-family home, Disadvantaged Community, Weatherized TierGround-source (geothermal) heat pump | $11,000 |
| New construction, apartment or home under 1,000 sq ft, Disadvantaged Community, Weatherized TierGround-source (geothermal) heat pump | $5,500 |
| Single-family homePartial-load air-source system upgraded to full load | $3,000 |
| Apartment or home under 1,000 sq ftPartial-load air-source system upgraded to full load | $1,500 |
Eligibility
Do I qualify?
You need to meet all 8 of these.
Each dwelling unit must be owned or controlled (renting counts) by a NYSEG electric customer with an active account that pays the System Benefits Charge.
Existing homes with one to four units, or one to four apartments in a larger building whose owners don't control the whole building. Manufactured homes are generally eligible for retrofit projects (contact the program for exact rules).
Air-source heat pumps qualify only in existing homes (including gut renovations); new construction qualifies only for ground-source heat pumps.
The heat pump must be installed by a NYS Clean Heat Participating Contractor, who submits the application.
What to doHire a contractor enrolled in NYS Clean Heat (search the program's Find a Contractor tool at cleanheat.ny.gov). NYS Clean Heat Heat Pump Program Manual, Version 3 (September 1, 2026) Get a quote from a contractor
The system must be new, sized to meet 100% of the home's heating load, and no new fossil-fuel equipment may be installed with it. Air-source units must be on the NEEP cold-climate list; ground-source units must meet ENERGY STAR.
The dwelling unit can't have already received NYS Clean Heat full-load incentives, and projects adding to an existing full-load heat pump system don't qualify. Homes that got partial-load incentives before can apply for full-load incentives.
Optional: homes that qualify for the Weatherized Tier get higher incentives — homes built after 2010, homes that completed a qualifying weatherization package (for NYSEG: the NYSEG/RG&E Home Insulation and Air Sealing Program), or homes whose heating load per square foot is below the program standard.
What to doWeatherize first (for example through the NYSEG/RG&E Home Insulation and Air Sealing Program or NYSERDA Comfort Home) so the project qualifies for the Weatherized Tier.
Homes in a state-designated Disadvantaged Community get the higher DAC rates and a cost cap of 85% instead of 70%; contractors check the address on NYSERDA's DAC map.
Equipment
What equipment counts
The program sets these minimums.
Listed by NEEP as a cold-climate ASHP (ccASHP), tested under AHRI 210/240, single-phase, cooling capacity under 65,000 Btu/h; sized for 100% of the building heating load.
Each heat pump must meet or exceed the ENERGY STAR Geothermal Heat Pump specification; must meet 100% of the load at design conditions.
Applying
How to apply
Your contractor applies for you. The contractor must submit the application within 60 days of installation.
- Find a NYS Clean Heat Participating Contractor.
Get a quote for a whole-home system sized to your full heating load (Manual J).
- Weatherize first if you can.
Homes built after 2010, homes that finished a qualifying insulation and air sealing package, or homes that meet the heating-load standard get the higher Weatherized Tier incentive.
- Contractor installs the heat pump.
To get the decommissioning incentive, the old fossil-fuel system must be removed or disconnected and documented.
- Contractor submits the post-installation application.
Required within 60 days of installation (30 days encouraged).
- Get the incentive.
As an instant discount on your invoice, or a check mailed to you or someone you designate.
Forms and instructions, including for applying by mailNYS Clean Heat Heat Pump Program Manual, Version 3 (September 1, 2026)
Questions about applying844-212-7823 or NYSCleanHeat@icf.com
Stacking
Use it with
Your address
Next steps
Check that it covers your address. Then, if you want, ask for a contractor quote.
Is it available at your address?
Before anything else
Your quote request is in If a contractor we work with serves your ZIP, they can contact you. We take one request per person; contact us to change it.
Get an email if this program changes
We'll write if its amount, status or deadline changes. Nothing else.
FAQ
Questions
How much does NYSEG NYS Clean Heat Heat Pump Incentives pay?
$1,500 to $21,000, depending on what you install. The table under How much you get lists each amount.
Do I need to be a New York State Electric & Gas customer?
Yes. It’s only for homes in New York State Electric & Gas customers, New York. See Do I qualify for the details.
Do I have to use a contractor?
Yes. The heat pump must be installed by a NYS Clean Heat Participating Contractor, who submits the application.
What’s the deadline?
No fixed deadline. Apply any time while it’s open.
Is it still available?
Yes. It was open when we last checked, on October 26, 2026.
Does a heat pump that heats only part of my home qualify?
No. Only systems sized to meet the full heating load of the home qualify; adding capacity to an existing partial-load system to reach full load has its own incentive.
Can I keep my old furnace or boiler as a backup?
Yes, with the lower full-load incentive; removing (decommissioning) the old fossil-fuel system earns the higher incentive, and installing new fossil-fuel equipment with the heat pump isn't allowed.
Are manufactured homes eligible?
Generally yes, for retrofit projects. Contact the program administrator for the exact rules and amounts.
Plain words
Words used on this page
- Heating load
- How much heat your home needs to stay warm in winter.
- Fossil-fuel heating
- Heating that burns gas, oil or propane.
References
Sources
This page is built from these official pages, run by the program itself.
When one of these pages changes, we re-check this page against it.
Nearby
More in New York
All of New York
EmPower+
Up to $14,000
Income-eligible New York owners and renters of one- to four-family homes get a no-cost home energy assessment and NYSERDA funding for air sealing, insulation, heat pumps, heat pump water heaters and electrical upgrades, free for low-income households and 50% of the cost for moderate-income households.
Checked Oct 26, 2026
All of New York
Geothermal Energy System Credit
Amount varies
New York homeowners who buy or lease a ground source heat pump (geothermal) system for their home can claim a state income tax credit of 25% of the cost, up to $10,000 for systems placed in service on or after July 1, 2025, with unused credit carried forward five years.
Checked Oct 26, 2026
All of New York
On-Bill Recovery Loan
Amount varies
NYSERDA loans of $1,500 to $25,000 for solar panels, heat pumps and energy efficiency work on one- to four-family New York homes, repaid through your utility bill over 5, 10 or 15 years, with a balance that can pass to the next owner.
Checked Oct 26, 2026